收藏本站
NOIL1SN3000A
.FOT starts before readout. When the EXPOSURE_1 signal goes low before the window readout has finished, the readout
is interrupted after the completion of the current line’s readout (line x in Figure 27).
wait till ROT
pix_vmem
FOT
FOT
DATA
L1
L2
L3
L x-1
L x
L1
EXPOSURE_1
wait till RO T
pix_reset
integration time
pix_sample
Figure 27. High Level Readout Timing
Dual Slope Integration Timing
If the dual slope enable bit is set high, dual slope
integration is controlled through the EXPOSURE_2 pin. If
the dual slope enable bit is set low, the dual slope integration
is disabled. Figure 28 shows the timing. The pix_reset signal
is controlled by the EXPOSURE_1 pin. When pix_reset
goes low, the dual slope reset of the pixel array is activated.
Bringing the EXPOSURE_2 pin high starts the dual slope
integration. The start of FOT is controlled by the falling edge
FOT
pix_vmem
of the EXPOSURE_1 pin. The EXPOSURE_2 pin must be
brought low during FOT to be ready for the next cycle.
Setup and Hold Requirements
EXPOSURE_1 and EXPOSURE_2 are deglitched using
two chained flipflops that clock on the sensor clock. As a
result, there is no setup requirement for both signals relative
to LVDS_CLKIN. The hold requirement is 15 clock periods
of LVDS_CLKIN.
DATA
L1
L2
L3
L4
L x
EXPOSURE_1
EXPOSURE_2
wait till RO T
pix_reset
wait till RO T
pix_reset_ds
DS integration tim e
integration tim e
pix_sample
Figure 28. Dual Slope Integration Timing
Readout Modes
The sensor is configured to operate in three readout
modes: training, test image readout, and normal readout.
These modes enable correct communication between the
sensor and the customer system.
Readout of Training Sequence
By setting the TRAINING_EN and BYPASS_MODE bit,
all data channels and the sync channel transmit alternating
the Idle_A and Idle_B word. Rotating the received Idle_A
and Idle_B words in the receiver allows correcting for skew
between the LVDS outputs and the receiver clock. You can
program the Idle_A and Idle_B words.
Readout of Test Image
By setting the BYPASS_MODE bit high and the
TRAINING_EN bit low, the sensor is configured to output
a programmable test pattern.
The sync channel operates as in normal readout and
enables frame and line synchronization. Every data channel
transmits a fixed, programmable word to replace normal
data words coming from the ADC. In this mode, the sensor
behaves as in normal readout. The sync channel transmits
programmable keywords to allow frame and line
synchronization. When not transmitting data from the ADC,
the data channels transmit the toggling Idle_A and Idle_B
words. As a result, the data stream from the sensor has a
fixed format.
http://onsemi.com
37
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
NOIL1SM0300A-WWC IC IMAGE SENSOR LUPA300 48LLC
NOIL2SC1300A-GDC IC IMAGE SENSOR LUPA1300 168PGA
NOIV1SE025KA-GDC IC IMAGE SENSOR 25MP 355PGA
NP100P04PDG-E1-AY MOSFET P-CH -40V MP-25ZP/TO-263
NP100P04PLG-E1-AY MOSFET P-CH -40V MP-25ZP/TO-263
NP100P06PDG-E1-AY MOSFET P-CH -60V MP-25ZP/TO-263
NP100P06PLG-E1-AY MOSFET P-CH -60V MP-25ZP/TO-263
NP109N04PUJ-E1B-AY MOSFET N-CH 40V MP-25ZP/TO-263
相关代理商/技术参数
NOIL1SM0300A-QDC 功能描述:IC IMAGE SENSOR LUPA300 48LLC RoHS:是 类别:传感器，转换器 >> 图像，相机 系列:* 标准包装:480 系列:- 象素大小:6.7µm x 6.7µm 有源象素阵列:768H x 488V 每秒帧数:52 电源电压:3.3V 类型:CMOS 成像 封装/外壳:48-QFP 供应商设备封装:48-QFP 包装:托盘 请注意:* 配用:4H2105-ND - HEADBOARD FOR KAC-004014H2104-ND - KIT EVAL FOR KAC-00401 其它名称:4H20954H2095-NDKAC-00401-CBC-LB-A0
NOIL1SM0300A-WWC 功能描述:IC IMAGE SENSOR LUPA300 48LLC RoHS:是 类别:传感器，转换器 >> 图像，相机 系列:LUPA300 标准包装:480 系列:- 象素大小:6.7µm x 6.7µm 有源象素阵列:768H x 488V 每秒帧数:52 电源电压:3.3V 类型:CMOS 成像 封装/外壳:48-QFP 供应商设备封装:48-QFP 包装:托盘 请注意:* 配用:4H2105-ND - HEADBOARD FOR KAC-004014H2104-ND - KIT EVAL FOR KAC-00401 其它名称:4H20954H2095-NDKAC-00401-CBC-LB-A0
NOIL1SM1300AWES 制造商:ON Semiconductor 功能描述:PW/H
NOIL1SM4000A 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:LUPA4000: 4 MegaPixel High Speed CMOS Sensor
NOIL1SM4000A-GDC 功能描述:IC IMAGE SENSOR LUPA4000 127PGA RoHS:是 类别:传感器，转换器 >> 图像，相机 系列:* 标准包装:480 系列:- 象素大小:6.7µm x 6.7µm 有源象素阵列:768H x 488V 每秒帧数:52 电源电压:3.3V 类型:CMOS 成像 封装/外壳:48-QFP 供应商设备封装:48-QFP 包装:托盘 请注意:* 配用:4H2105-ND - HEADBOARD FOR KAC-004014H2104-ND - KIT EVAL FOR KAC-00401 其它名称:4H20954H2095-NDKAC-00401-CBC-LB-A0
NOIL1SN3000A-GDC 功能描述:IC IMAGE SENSOR LUPA3000 369PGA RoHS:是 类别:传感器，转换器 >> 图像，相机 系列:* 标准包装:480 系列:- 象素大小:6.7µm x 6.7µm 有源象素阵列:768H x 488V 每秒帧数:52 电源电压:3.3V 类型:CMOS 成像 封装/外壳:48-QFP 供应商设备封装:48-QFP 包装:托盘 请注意:* 配用:4H2105-ND - HEADBOARD FOR KAC-004014H2104-ND - KIT EVAL FOR KAC-00401 其它名称:4H20954H2095-NDKAC-00401-CBC-LB-A0
NOIL2SC1300A-GDC 功能描述:图像传感器和彩色传感器 LUPA1300-2 COLOR PGA168 RoHS:否 制造商:Avago Technologies 类型:Color Sensors 工作电源电压:2.5 V 封装 / 箱体: 图象大小: 颜色读出:Color 最大工作温度:+ 70 C 最小工作温度:- 25 C 封装:Reel
NOIL2SM1300A-GDC 功能描述:IC IMAGE SENSOR LUPA1300 168PGA RoHS:是 类别:传感器，转换器 >> 图像，相机 系列:* 标准包装:480 系列:- 象素大小:6.7µm x 6.7µm 有源象素阵列:768H x 488V 每秒帧数:52 电源电压:3.3V 类型:CMOS 成像 封装/外壳:48-QFP 供应商设备封装:48-QFP 包装:托盘 请注意:* 配用:4H2105-ND - HEADBOARD FOR KAC-004014H2104-ND - KIT EVAL FOR KAC-00401 其它名称:4H20954H2095-NDKAC-00401-CBC-LB-A0